ABNOX AXDV-P50 Montageanleitung Seite 44

EN
Pressure line connection
WARNING! Risk of injury due to compressed air and material
pressure!
Only qualified personnel may work on the pressure plant in accordance
with the safety regulations.
When working on the pressure plant, be sure to:
Depressurise the plant before beginning work.

Do not remove or disable safety equipment.

Do not set pressures above the maximum permitted values.

Install all hoses safely so that the pressure lines cannot be

damaged by moving machine or plant components.
Do not put the pressure plant into operation until work is

completed.
Hose installation: Control air
1. Unscrew the retaining cap from the screwed connection and push it over
the hose.
2. Push the open hose end onto the connection port on the screwed
connection.
3. Screw the retaining cap back onto the screwed connection and tighten.
Material:
1. connection to G 1/4" thread
IMPORTANT!
Only hoses which can withstand the maximum working pressure of the
pressure line, may be used.
Installation instructions
WARNING! Risk of injury!
To prevent personal injury and/or property damage it is essential to
observe the following when installing the device in a machine or plant:
The device must be installed in a machine or plant in such a way as to rule out
hazards like:
 the escape of high-pressure fluids
 defects in the compressed air supply
 electricity
 malfunctions of the device, machine or plant
 failure or malfunction of plant control
44