Operation - Zipper ZI-BM870ECO Bedienungsanleitung

Forward clutch distance adjust
If the forward clutch distance is too short,you
can adjust the forward clutch line to L(Fig.D1)
or L(Fig.D2) direction.
If the distance is too long,you can adjust to re-
verse direction.
Let this adjustments be performed by trained
persons if you do not have the required technical
abilities.
Handbar height adjustment (Fig.D4)
To adjust the handbar height,loosen the the
bolts1 on the two side, select the appropriate
height and retighten the bolt.
Cutting height adjustment (Fig.D5)
steplessly adjustable cutting height up to
approx. 6cm!
Loosen nut1 and 2, move the skids to the re-
quired height and retighten the nuts.
Both skids must be set to the same height!
Cutting bar adjustment(Fig.D6)
After a certain usage time, the upper blade and
down blade of the cutting bar become loosen,you
can take out some pieces of washers1.
Four positions must be set to the same
thickness!
Fill up motor oil
See E1, remove oil tank cap 3. Fill in suitable
motoroil up to lower edge up oilfiller neck.
MOTOROIL TO BE USED:
High Quality SAE10W-40 motor oil for 4-stroke
engines.
Refuelling
Use standard commercially available unleaded
petrol/gas.
Do not use petrol/oil mixtures.
Take care when refuelling that no foreign par-
ticles get into the fuel tank.
After refuelling tighten the tank cap again.

7 OPERATION

cold engine start-up
Bring the throttle lever 1 (Abb. A) into position:
Position yourself next to the machine with suffi-
cient distance to the cutting bar.
Pull out energetically on the ignition knob2
(Fig.E1) and release it once the engine has
started
.
After a few seconds, position the throttle lever in
an intermediate position between the symbol and
the symbol
Hot engine start up
Put the throttle lever in an intermediate position
between
Position yourself next to the machine with suffi-
cient distance to the cutting bar.
Pull out energetically on the ignition knob2
(Fig.E1) and release it once the engine has
started
.
Switching on the cutter bar
Unlock the safety catch 7 (Fig. A). Fully depress
the cutting clutch lever 6 (Fig. A) and hold it
down tight.
To Switching off the cutter bar just release the
cutting clutch lever 6 entirely.
Engaging the wheel drive
Depress the forward clutch lever 8 (Abb. A). Max.
forward speed is 2.5km/h at fully depressed lev-
er.
To switching off the wheel drive just simply re-
lease the lever entirely.
Switch machine off
Sickle bar mower in a position across the slope.
18