Operation; Engine Start / Stop; Height Adjustment - Zipper ZI-BRM35 Betriebsanleitung

14

OPERATION

14.1 Engine Start / Stop

Start the engine, if you have your mower mounted correctly:
Move the Gas-lever to the START position. (fig. 22)
Pull the engine brake handle (2) against the handle (fig. 22). Pull the pull-start handle (9) until
resistance is felt and then pull out quickly
Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
Set Lever to the engine running to RUN (fig. 22)
Let the engine brake handle
WARNING! Keep hands and feet away from rotating parts.

14.2 Height adjustment

CAUTION: Do they at no time changes to the adjustment of the machine with-
out shutting off the engine before.
Your mower is equipped with a central height adjustment which 8 different height settings from
20 - 60 mm offers.
Turn off the engine and wait before changing
the cutting height to the rotating parts are no
longer rotate.
To change the cutting height, push the joystick in the
direction of the wheel. Turn to the left to reduce the
cutting height, turn clockwise increases the cut height
(fig. 24). All wheels will be at the same height of the
cut.
Note: The cutting height can be chosen so that the
blade on uneven surfaces do not touch the ground!
Mowing to low cutting adjustment should be per-
formed only on a level, and plan lawns.
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-BRM35 / ZI-BRM56 / ZI-BRM60
Fig. 22
by.
(2) going to stop the engine and blade
Fig. 23
Fig. 24
OPERATION
34