Check The Oil Level; Maintenance Of The Air Filter; Damaged Blades; Change The Blade - Zipper ZI-BRM35 Betriebsanleitung

15.1

Check the oil level

Provide lawn mower with all wheels on the specific
Oil tank cap (12) unscrew counter clockwise and wipe dipstick.
Replace the dipstick all the way into the filler
Pull out the dipstick and check the oil level in a horizontal
The oil level must be between the maximum and minimum mark. (see 13.7)
15.2

Maintenance of the air filter

Note: Dirty air filters reduce the engine efficiency by restricting air flow to the carburetor. Regu-
lar monitoring, especially in dusty atmosphere is therefore essential!
Attention: Never clean the air filter elements with gasoline or flammable solvents. Fire or explo-
sion!
Do not let the engine run without his air filter: This dust penetrates through the car-
buretor and causing premature
15.3

Damaged blades

Note: Wear thick gloves for mounting and sharpening the cutting blade. Check that the blade is
always well balanced.
If the blade is pushed, despite all precautions for foreign objects / obstacles, first turn off the en-
gine and disconnect the spark plug. If the blade stops, tilt the mower and the blade checked for
possible damage.
Deformed or bent blades must not be re-aligned.
Damaged parts must be replaced immediately. After hitting an obstacle, the mower must be
checked by an authorized service workshop. Sure before use that knife and knife holder are not
damaged. If necessary, replace such parts or checked. Never work with an unbalanced blade -
this cause vibration and further damage may result.
15.4

Change the blade

When changing the blade are to protect your
the spark plug is to be
Use to help a holding pen as a blocking device for the knife. The blade mounting screw has a
normal right hand thread.
When reassembling the slip clutch on the exact order in which these components were previously
installed (Fig. 29).
The screw diameter must be attached to the specified torque of 45 Nm
Make sure that the cutting edges pointing in the direction in which the motor also rotates.
When replacing, use only cutter that match the original enclosed blade in quality and
size.
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-BRM35 / ZI-BRM56 / ZI-BRM60
pipe.
deducted.
To loosen this screw is best to use a 17 mm socket
section.
position.
hands, wear appropriate
MAINTENANCE
gloves. Before
wrench.
37