Remove The Mulch Wedge - Zipper ZI-BRM35 Betriebsanleitung

When the halves with 3 screws below the outside as shown in fig. 10 Bolt together.
Handle the grass catcher cover with 4 screws on the inside
screwdriver screw (Fig. 8)
Put lid on grass catcher pan and all around good push in terminal block
Fig 11
Cover with grass catcher tray screw holes at the
sides. (Fig. 13)

13.5.1 Remove the mulch wedge:

Note: Carry out only with the engine stopped and complete stop the cutter!
Lift the rear discharge door
and remove. (Fig. 15)
Fig. 14
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-BRM35 / ZI-BRM56 / ZI-BRM60
(Fig. 14) and remove the mulching by releasing him at the notch
Fig. 15
(Fig. 7) of the grass catcher with star
(Fig. 9).
Fig 12
ASSEMBLY
Fig 13
31