Maintenance - Zipper ZI-BRM35 Betriebsanleitung

Lower the side door - the door is now fixed on the side
discharge (fig. 27)
What is mulch?
When mulching the grass or foliage is cut in one
natural fertilizer again.
Tips to mulch mowing:
- Regular pruning to max. 2 cm (from 6 cm to 4 cm tall grass)
- The blades should be as sharp
- Mow wet grass
- Adjust the max. an engine speed
- Move the mower at a walking pace
- Regularly clean the mulching plug, the housing interior and the mower blade
15

MAINTENANCE

Don't clean or do maintenance on the machine while it is still connected to the power
supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator. Faults or defects that may affect the safety of the
Repair work may only be performed by qualified personnel!
At regular intervals, you should also check the bolts and screws are tight. Worn or poorly tight-
ened nuts and bolts can cause serious damage to the engine or frame
Never store with filled tank or gas cans in a closed space where gasoline gases to escape and
reach a high temperature and can then inflame the
storing the mower.
To reduce the risk of
all grass residues, leaves and
Regularly check the condition of the baffle plate and the grass
Replace these parts if they are
Before storage of the
Regularly check the oil level and add if
Frequently check the mower and ensure that any Grass residues are located under the
Grease the wheel axle and the bearings.
Check the blade often to ensure a clean cut. The cutting blade should be sharp and well balanced
(no imbalance).
If the blade hits an obstacle, stop the
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-BRM35 / ZI-BRM56 / ZI-BRM60
fire, clean the mower, especially
grease residues.
damaged.
mower, you should change the oil
necessary,
mower.
Fig. 27
step, then fine chopped and then ejected as a
A T T E N T I O N
machine, must be rectified immediately.
mower. Let the Motor cool the way before
the engine, exhaust and fuel tank. Remove
catcher.
add oil.
MAINTENANCE
cover.
36