Operation; Engine Start / Stop; Height Adjustment - Zipper ZI-BRM40 Bedienungsanleitung

16

OPERATION

16.1 Engine Start / Stop

Start the engine, if you have your mower mounted correctly:
Move the Gas-lever to the START position. (fig. 37)
Pull the engine brake handle (2) against the handle (fig. 38). Pull the pull-start handle (9)
until resistance is felt and then pull out quickly
Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
Set Lever to the engine running to RUN
Let the engine brake handle
WARNING! Keep hands and feet away from rotating parts.

16.2 Height adjustment

CAUTION: Do they at no time changes to the adjustment of the
machine without shutting off the engine before.
Your mower is equipped with a central height adjustment which 8 different height settings
from 20 - 60 mm offers.
Turn off the engine and wait before changing the cutting height to the rotating parts
are no longer rotate.
To change the cutting height, push the joystick in the direction of the wheel. Turn to the left
to reduce the cutting height, turn clockwise increases the cut height (fig. 39). All wheels will
be at the same height of the cut.
Note: The cutting height can be chosen so that the blade on uneven surfaces do not touch
the ground! Mowing to low cutting adjustment should be performed only on a level, and plan
lawns.
Z.I.P.P.E.R Maschinen Austria
Benzinrasenmäher / Gasoline lawn mower ZI-BRM35 / ZI-BRM40 / ZI-BRM60
Fig. 37
(2) going to stop the engine and blade
www.Zipper-maschinen.at
Fig. 38
by.
OPERATION
Seite 32