Specifications - Makita UH5580 Originalanweisungen

ENGLISH (Original instructions)
1. Switch trigger B
2. Switch trigger A
3. Switch trigger C
4. Hook complete
5. Tool's cord
6. Extension cord
7. Hook
8. Tool
9. Holder
10. Waist cord hook
11. Cord

SPECIFICATIONS

Blade length
Strokes per minute (min
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Symbol
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
................ Wear eye protection.
.................DANGER - Keep hands away from blade.
................ Do not expose to rain.
................ Remove plug from the mains
immediately if the cable is damaged or
cut.
................ Only for EU countries
Do not dispose of electric equipment
together with household waste
material!
In observance of the European
Directive, on Waste Electric and
Electronic Equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
6
Explanation of general view
12. Arm cord hook
13. Cutting height
14. 10 cm
15. Trimming direction
16. Tilt the blades
17. Hedge surface to be trimmed
18. Press
19. Chip receiver
20. Nut
21. Shear blade
22. Branch catcher
Model
-1
)
END220-7
23. Hooks
24. Fit the hooks into groove
25. Grooves
26. Press the levers on both sides
27. Unlock the hooks
28. Screws
29. Blade cover
30. Under cover
31. Gear housing cover
32. Crank
33. Ellipse of shear blade
UH5580 UH6580
550 mm 650 mm
1,500
970 mm 1,049 mm
4.3 - 4.5 kg 4.3 - 4.5 kg
an environmentally compatible
recycling facility.
Intended use
The tool is intended for trimming hedges.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
UH7580
750 mm
1,500 1,500
1,157 mm
4.3 - 4.5 kg
/II
ENE014-1
ENF002-2
GEA010-2