Safety Instructions - cecotec FAST&FURIOUS 5040 ABSOLUTE Bedienungsanleitung

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
All safety instructions should be closely followed when using
the appliance.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
Do not immerse the cord, plug, or any non-removable part
of the appliance in water or any other liquid. nor expose the
electrical connections to water. Make sure your hands are dry
before handling the plug or switching on the appliance.
Never immerse the appliance in water. Do not reach into the
water!
Do not twist, bend, strain, or damage the power cord
in any way.
Protect it from sharp edges and heat sources. Do not
let it touch hot surfaces. Do not let the cord hang over the edge
of the working surface or countertop.
The appliance is not intended to be operated by means of an
external timer or separate remote-control system.
Turn off and unplug the appliance from the mains supply when
not in use and before cleaning it.
Pull from the plug, not the cord, to disconnect it from the outlet.
This device is designed to iron fabrics. This product is designed
only for household use.
It is not suitable for commercial or industrial use. Do not use
outdoors.
To protect against burns or injuries to persons, do not iron
textiles while being worn on the body.
Do not use any accessory that has not been recommended by
Cecotec, as they might cause injuries or damage.
Place the appliance on a dry, stable, flat, heat-resistant surface.
The temperature of accessible surfaces may be high while in
use and could cause burns. Do not touch hot surfaces while in
use or immediately after.
Unplug the appliance immediately if fire or smoke is observed.
Do not leave the appliance unattended while in use.
Unplug it from the power supply when you finish using it and
before leaving the room.
The appliance must not be plugged in when filling or emptying
the water tank.
The tank cap must not be open when the appliance is switched
on.
The use of tap water is recommended. If the lime content of the
tap water is too high, use a mix composed of 50 % of tap water
and 50 % of water with low mineral content. Do not use only
water with low mineral content.
Burns can occur when touching hot metal parts, hot water,
or steam. Hot water may leak from the iron. Be careful when
filling or turning the steam iron upside down.
To protect against burns or injuries, do not direct steam toward
persons or animals when ironing.
The iron must be used and placed on a stable surface. When
placing the iron on its stand, make sure that the surface is
stable.
Keeping the iron at maximum temperature for too long may
cause discolouration, which will not affect the performance of
the appliance.
Do not try to repair the product by yourself. Contact the official
Technical Support Service of Cecotec.
To ensure the correct operating of the device, cleaning and
maintenance tasks must be carried out according to this
instruction manual. Turn off and unplug the appliance before
moving and cleaning it. Allow it to completely cool down before