Français
2 - COMME ASPIRATEUR EAU
Oter le sac fi ltrant papier et la cartouche fi ltre.
AGTTENTION:
Lorsque les liquides aspirés dans la cuve-bidon atteignent le
niveau maximum admissible, l'aspiration est automatiquement
bloquée par le fl otteur de sécurité.
L'augmentation du nombre de tours moteur et l'absence
d'aspiration préviennent l'utilisateur.
Eteindre immédiatement l'appareil et vider la cuve-bidon.
3 - ASPIRER DE GRANDES QUANTITES DE LIQUIDES (fi g. "C1")
•
Pour aspirer des liquides dans des récipients, éviter de plonger complètement le suceur fente
long afi n d'assurer un débit d'air partiel.
======================================================================
--- D - ENTRETIEN ---
Avant d'effectuer une quelconque intervention d'entretien, de nettoyage
ou de remplacement du fi ltre mousse, toujours débrancher la fi che du
cordon d'alimentation électrique. (fi g. "003").
1 - SAC FILTRANT PAPIER (fi g. "D1" - "D2" - "D3")
(Modèle "TechnoCleaner 15" ................................Code emballage 83 144B0I).
(Modèles "TechnoCleaner 18 e 20" .......................Code emballage 83 140B0K).
(Modèles "TechnoCleaner 30 e 35" .......................Code emballage 83 142B0K).
Ne pas réutiliser le sac qui devra toujours être remplacé.
Pour remplacer le sac fi ltrant papier
•
Détacher le collier en plastique du raccord d'entrée d'air (fi g. "D1")
•
Extraire le sac fi ltrant papier (fi g. "D2").
•
Fermer le collier à l'aide du bouchon correspondant (fi g. "D3").
2 - CARTOUCHE FILTRE (fi g. "D4" - "D5" - "D6")
Fourni avec les modèles: "TechnoCleaner 18 - 35" (code 83 200BOG)
Optionnel pour les modèles: "TechnoCleaner 15 - 20 - 30" (code 83 201BOG)
•
Enlever la cartouche fi ltre du support moteur.
•
Procéder au nettoyage fréquent de la cartouche fi ltre (b) à l'aide d'un pinceau à soies
souples (fi g."D4").
•
Pour un nettoyage en profondeur, utilisez un robinet en dirigeant le jet d'eau de l'intérieur
vers l'extérieur (fi g. "D5").
26
WARNINGS
Keep these instructions in a safe place.
• Carefully read these warnings and instructions.
• An electrical appliance is not a toy. Use and keep the equipment out of reach of children.
• All packaging (plastic bags, cartons, etc.) must be kept out of reach of children.
• This appliance is intended for use with alternating current only. Before switching it on, make sure the
power rating is the same as the one indicated on the rating plate.
• ONLY plug the appliance into earthed power sockets with a minimum power of
10A (fi g. 001).
• Do not pull on the power cord to remove the plug from the socket (fi g. 002).
• Make sure the mains electricity supply has a residual current device (circuit breaker).
• Fully unwind the power cord before switching on the appliance.
• Only use an extension cord in perfect condition. Make sure it is the right diameter for the appliance
power.
• Never allow the power cord to run over sharp edges; avoid compressing it.
• Never leave the appliance operating without supervision.
• Do not expose the machine to the elements (rain, frost, sun, etc.).
• Never use the appliance:
- with wet or damp hands;
- if the appliance has fallen and shows obvious signs of breakage or operating problems;
- if the socket or power supply cord are defective.
• ALWAYS unplug the appliance immediately after use (fi g. 003) and before any
cleaning or maintenance operations.
• Refer all repairs to qualifi ed service personnel that stock original manufacturer-supplied spare parts.
It can be extremely dangerous to repair the appliance yourself.
• In compliance with current laws, any appliance that has reached the end of its lifecycle must be rendered
non-useable by cutting off the power supply cord before disposal.
• Do not vacuum infl ammable, explosive or corrosive substances (fi g. 004).
• Do not use the machine in rooms saturated with gas.
• Clean the machine with water only. Do not use trichloroethylene (TCE), solvents or abrasive
detergents.
The manufacturer declines all responsibility for any damage caused by improper
use or use not conforming to the instructions supplied, tampering with the appliance
and/or inadequate maintenance.
230V~
50/60Hz
Fig. 001
English
Fig. 002
Fig. 003
11