Alex Sew Fun Bedienungsanleitung Seite 10

1. Make sure the Presser Foot is raised.
2. Remove cover by sliding it to the left.
3. Place a fully wound bobbin in the Bobbin
Holder leaving about 10 " of thread trailing out.
4. Pull the loose end towards
the back of the machine so
that it rests in the indentation.
6. Bring the Needle thread around to the
front. Pull it gently up and you will see it
has caught the bobbin thread. Pull the
bobbin thread all the way through.
Note: It is essential that the threading of both the top and
the bottom be done properly. Check carefully and sew
Make sure the machine
is threaded correctly fi rst!
one practice stitch before beginning.
Bobbin Holder
Thread Gap
5. Turn Hand Wheel to-
ward you. The Needle will
go down. Keep turning
the wheel.
7. Pull the 2 threads away from you
until there is about 10" / 25.5 cm of
loose thread behind the machine.
8. Slide the cover back into place.
9