Paramondo JAM Montageanleitung Seite 9

Sicherheitshinweise • Safety instructions
Transport and storage
The packaging of the awning must be protec-
ted against wet and damp. Soaked packaging
can come loose and cause accidents.
Transport the awning to the place of instal-
lation in the correct direction for fitting to
prevent turning it in small spaces.
If the awning is to be installed in an elevated
area, the area underneath must be blocked
off when the awning is raised so that nobody
is under the suspended load.
Proceed in the same manner when uninstal-
ling the awning.
The awning must be protected against
penetrating damp when in storage!
Awnings must be stacked and unstacked so
that they do not prove a hazard to persons
due to tipping over or rolling out of position.
Only create storage facilities and stacks
that can securely take the load. Ensure that
the permissible loads of shelves and other
load-bearing components are not excee-
ded.
You must comply with the general goods
storage principles.
Fixing material
The awning is delivered without any
fixing material
The fixing material must be selected by the
fitter to suit the existing fitting base and
reconciled in accordance with the require-
ments of the system and fitting base.
You must comply with the specifications for
the required screw anchor pull-out forces.
When using the fixing material ordered as
fitting accessories, we do not assume any
liability for professional fitting. The fitter is
solely responsible to ensure that the fixing
material is suitable for the respective fitting
base and that the fitting is done professio-
nally.
You must adhere to the respective fitting
instructions of the screw anchor manufactu-
rers!
Test run
Persons must not stand in the moving area
or beneath the awning when it is extended
for the first time. The fixing materials must
be visually inspected after the first extensi-
on.
Installation
To make sure that the awning is correctly as-
sembled and thus ensure the optimal perfor-
mance of the finished product, the following
instructions must be observed:
Perform the fitting work in accordan-
ce with the applicable occupational
health and safety guidelines and stan-
dards.
Safety ropes and/or safety belts fixed to the
articulated brackets may only be removed
after testing the attachment of all compo-
nents.
Check all equipment (scaffolding, ladders,
tools, etc.) and safety equipment (belts, ro-
pes, etc.) for da,age prior to use.
Always use suitable protective equipment
(gloves, safety boots, goggles, hearing pro-
tection, etc.).
If several persons work on the system, their
activities must be coordinated.
The working area beneath the awning must
be blocked off and protected to ensure that
persons cannot walk beneath the suspended
load without any protection.
The fitting and service personnel must be
instructed in accordance with all safety regu-
lations.
The position chosen by the user for the ins-
tallation of the product has to be such that
an adequate load-bearing capacity and the
necessary space for opening the awning in
its entirety is guaranteed.
www.paramondo.de
9