Maintenance - Makita LC1230 Betriebsanleitung

Dust collection (Fig. 17)
CAUTION:
Do not touch any part of the dust box except its handle
immediately after operation; it may be extremely hot and
could burn your skin.
This tool is equipped with the dust box to collect dust and
cut chips. When the dust box is full, hold the handle of
the dust box and raise it slightly. Then pull the dust box
out of the tool base. Empty the dust box of its contents.
Carrying the tool (Fig. 18)
CAUTION:
The chain for transportation shall be adjusted to minimize
the accessible zone of the saw blade before transporting
the tool.
Fold down the tool head to the position where you can
attach the chain to the hook on the handle. Grasp the
carrying grip when carrying the tool.
10

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacing saw blade
Continuing to use a dull and worn blade may cause
motor overload and decreased cutting efficiency. Replace
with a new blade as soon as it is no longer effective.
Replacement of carbon brushes (Fig. 19 & 20)
Replace carbon brushes when they are worn down to the
limit mark. Both identical carbon brushes should be
replaced at the same time.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.