Functional Description - Makita 9046 Bedienungsanleitung

7. Use of this tool to sand some products, paints
and wood could expose user to dust contain-
ing hazardous substances. Use appropriate
respiratory protection.
8. Be sure that there are no cracks or breakage
on the pad before use. Cracks or breakage
may cause a personal injury.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► Fig.1: 1. Lock button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Front grip
► Fig.2: 1. Front grip
The front grip position can be changed in 90° incre-
ments. Pull the front grip and rotate it to the desired
position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive
paper
For conventional type of abrasive
paper with pre-punched holes
(standard equipment):
Turn the clamp lever counterclockwise. Insert the paper
end into the clamper, aligning the holes in the paper
with those in the pad. Then return the clamp lever to the
original position to secure the paper. Repeat the same
process for the other end of the tool, maintaining the
proper paper tension.
3
1. Conventional type of abrasive paper 2. Clamp lever
3. Pad
► Fig.3
For the velcro type of abrasive paper
(accessory)
► Fig.4: 1. Velcro type of abrasive paper 2. Pad
Remove all dirt or foreign matter from the pad. Attach
the paper to the pad, aligning the holes in the paper with
those in the pad.
CAUTION:
• Always use velcro type of abrasive papers.
Never use pressure-sensitive abrasive papers.
Dust bag
► Fig.5: 1. Mark 2.
port 5. Dust spout
To install the dust bag, align the
entry port with the
and fit the entry port onto the dust spout. Then turn the
dust bag clockwise to secure it in place.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
To remove the dust bag, follow the installation proce-
dures in reverse.
5 ENGLISH
1
Open
Mark 3. Dust bag 4. Entry
mark on the bag's
mark on the dust spout of the tool
2