Technical Data; Declaration Of Conformity - AEG AR 4025 BT Bedienungsanleitung

ENGLISH
82
Fault Potential cause
Connection 4 in the
ISO connection A
Station preset
(permanent posi-
does not work.
tive) is not properly
connected.
The USB port
is designed for
devices which work
according to the
USB standard. Not
Unit does not all devices on the
work on the market conform
USB port. to this standard. A
device which does
not function ac-
cording to the USB
standard may have
been connected.
SD/MMC
The device is not
memory card
reading the card.
does not work.
A connection
Bluetooth is turned
cannot be
off on your mobile
established via
phone.
Bluetooth.

Technical Data

Solution
Check the cable
General
connections. To
Input voltage
do so, refer to
Power consumption
the "Connection"
chapter Operating temperature
Humidity (no condensation)
Dimensions (L x W x H)
Weight
Connect a device
Maximum power output
which works ac-
cording to the USB
standard. Ensure
Radio
that the data
Frequency range FM (UKW)
storage device is
Usable reception (UKW)
formatted with the
Channel separation
FAT32 file system.
Frequency range (MW)
Usable reception (MW)
Check the card.
Insert it with the
CD-Player
printed side facing
Signal to noise ratio
right. Ensure that
Frequency response
the data storage
device is formatted
with the FAT32 file MP3/WMA format requirements
system.
Compression rate
Sampling rate
Activate Bluetooth
in your mobile

Declaration of Conformity

phone.
ETV - Elektro-Technische Vertriebsgesellschaft mbH hereby
declares that the unit AR 4025 BT complies with the basic
requirements of Automotive EMC Directive 2004/104/EC.
A copy of the Declaration of Conformity can be requested
from the address given.
12 V =
< 10 A
+5 ... +40 °C
5 - 90 %
178 x 175 x 50 mm
1.5 kg
4 x 40 W (at 14.4 V =)
87.5 - 108 MHz
9 µV
>25 dB
522 - 1620 kHz
28 dBu
65 dB
20 Hz - 20 kHz
16 - 320 kBit/s
44.1 kHz