Music Playback Via A2Dp (Advanced Audio Distribution Profile); Cleaning; Safety Advice; Troubleshooting - AEG AR 4025 BT Bedienungsanleitung

Music playback via A2DP
(Advanced Audio Distribution Profile)
This involves a cross-manufacturer Bluetooth profile.
Stereo-audio signals are transmitted wireless via stream-
ing between the playback unit (source) and receiver unit.
To control the source remotely, the playback unit must
support the AVRCP profile (Audio Video Remote Control
Profile).
Full functionality cannot be guaranteed due to the differ-
ent unit manufacturers, models and software versions.
After you have connected the units to each other,
‹
start playing the music in your mobile phone.
Use the (20) button (20) or
‹
or previous music title.

Cleaning

Safety advice

CAUTION:
Possible damage to the unit
►
Ensure that no moisture gets into the unit during
cleaning to prevent irreparable damage to the unit.
Cleaning
Always clean the housing with a slightly damp cloth.
‹

Troubleshooting

This chapter contains important advice on identifying
faults and troubleshooting. Follow the instructions to
prevent hazards and damage.
Safety advice
WARNING:
Follow the safety instructions below to prevent hazards
and damage to property:
►
Repairs to electrical devices may only be carried
out by qualified persons who have been trained by
the manufacturer. Significant risks for the user and
damage to the unit may arise from faulty repairs.

Fault causes and troubleshooting

Before sending the unit to our customer services, use the
following table to check whether you can repair the fault
yourself.
Fault
Cannot switch
on the unit.
No sound
The CD jumps.
(19) to select the next
The CD does
not load or
eject.
Function but-
ton does not
work.
Radio and/or
the automatic
station preset
does not work
ENGLISH
Potential cause Solution
The ignition is not Turn the key to
turned on. start the ignition.
The volume is set at Increase the
the minimum level. volume.
The cable is not Check the cable
connected properly. connections.
The installation Correct the
angle exceeds 30°. installation angle.
Clean the CD or
The CD is very dirty
insert a different
or faulty.
CD.
There is already a
Remove the CD.
CD in the unit.
The CD has been Insert the CD with
inserted upside the label facing
down. upwards.
Clean the CD or
The CD is dirty or
insert a different
faulty.
CD.
The CD format is
Insert a different
not supported by
CD.
the unit.
Check the self-
Fault on a CD which
burned CD in a
you have burned
different playback
yourself.
unit.
Air condition
The temperature in the vehicle until
the vehicle is too the temperature
high. returns to the oper-
ating temperature.
Switch off the unit
Condensation on
for a few hours and
the laser lens
then try again.
Disassemble the car
Transport screws radio, remove the
have not been transport screws
removed. and re-install the
car radio.
There is a fault on Press the RESET
the unit. button (4).
The control panel Check that the
is not attached control panel is
properly. attached securely.
The antenna cable Check that the an-
is not connected tenna is connected
properly securely.
The transmitter Manually tune the
signals are too weak stations.
81