Element one VERSIS 150-4 4:3 Einbau- Und Bedienungsanleitung Seite 28

Einbau - und Bedienungsanleitung / Installation- and operating instructions / Instructions de montage et d'emploi
English
Command Function
move up Unit opens
move down Unit closes
display on Switches display on
display off Switches display off
stop Stops monitor movement
status Requests information on
current position of display
devicedetails Requests information on type
of unit
protocol Requests information on
Ethernet protocol version
check To check whether connection
to unit is working
lock on Blocks control of the unit with
the push button temporarily
lock off Cancels temporary blocking of
push button control
lock perm on Blocks control of the unit with
the push button permanently
D
lock perm off Cancels permanent blocking
of push button control
Notizen / Notes / Notes
28
IP command list (based on Ethernet Protocol Vers. 1.00)
Response/message
OK: if display retracted or movement stopped
ERROR: if display moving in or out
OK: if display extended or movement stopped
ERROR: if display moving in or out
With CONVERS and MODIS, this command is followed by the
response,
ERROR, if the displays are retracted!
always OK, even if display is already switched off
always OK
OK open: if display extended or stopped
OK closed: if display retracted
OK display system
OK 1.00: in the case of Ethernet protocol vers. 1.00
OK: if display fully retracted or extended
ERROR: if display in intermediate position
Unit response is always OK if the unit can be contacted over the
network, no response if it cannot be contacted
Temporarily = until unit is restarted
Unit response always OK, even if already temporarily blocked
Unit response always OK, even if not blocked
Permanently = until block is cancelled by "lock perm off" command;
cancellation by turning off the supply is not possible
Unit response always OK, even if already permanently blocked
Unit response always OK, even if not blocked
© ELEMENT ONE Multimedia GmbH