Connections And Wiring - auna MD-140-BT Anschluss- Und Anwendungshinweise

Wiring Diagram
Cautions
• The said product is powered by means of a 12VAC accumulator which is grounded via the negative electrode;
• Please connect as per the wiring diagram so as to avoid any device damage;
• Before connection, strip off the insulation layer long as 5mm on both ends of the wires;
• Do not power on until connection is finished;
• Insulate any exposed live part in order to prevent short-circuit with the automobile chassis. Bundle all the wires
and cables so as to prevent any terminals making contact with any metal object;
• Important: As for any automobile equipped with computer or satellite navigation system,
Attention when connecting speakers:
• Do not use any grounded speakers;
• The power of the speaker in use must exceed 40W as it is required to accept maximum output power of the
amplifier;
• The speaker has resistance ranging between 4~8ohm. Any resistance not covered by such range could affect
output power and even damage the speaker or the said product;
• The speaker wires should be approximately 30mm away from the antenna and antenna extension cable; Please
follow the diagrams below to connect correctly so as to safeguard either the speaker
• or the said product:
m u l t i m e d i a

Connections and Wiring

http://www.auna-multimedia.com
16