General Guidelines; Installation; Cleaning And Maintenance - Velleman VDL10DL Betriebsanleitung

3. General Guidelines

• Only operate this device with the supplied power adapter. Do not use the VDL10DL outdoors.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust. Respect a min.
distance of 50cm between the projector and the illuminated surface.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur will probably be caused by unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty and may damage the device.
4. Installing or Replacing the Lamp
Loosen the two screws in the base and remove the plastic ball. Remove the old lamp and insert a new one, fixing the
two screws into place. Only install the lamp when the device is unplugged from the mains. Replace the lamp if it is
damaged but take care to let the lamp cool down before you do this.
Do not install lamps with a higher wattage than that for which the device was designed. Use one 12V/15W lamp
(LAMP10DL).

5. Installation

CAUTION : Make sure there are no inflammables within a radius of 50cm when you are mounting the device.
Connect the device to the mains using the supplied AC adapter. Do not connect the device to the
mains directly.
6. Operating Instructions
Insert the adapter's DC jack into the device and connect the other end with the mains. Put the ON/OFF button in the
ON-position. The device starts rotating at a steady pace. Put the ON/OFF button in the OFF-position to deactivate
the device.

7. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, mounting supports and connections should not be modified or tampered with e.g. do not drill extra
holes in mounting supports, do not change the location of the connections, ...
3. The electric power supply cables should be undamaged. Have this device installed by a qualified technician.
4. The moving parts must show no traces of wear and tear and should be well-balanced.
5. Disconnect the device from the mains before cleaning it.
6. Wipe the device clean regularly using a moist and clean cloth. Do not use alcohol or solvents on the device.
7. The user should only replace the lamp and the fuse when necessary (see also 4. Installing or Replacing the
Lamp on page 1). Actual repairs should always be handled by a qualified technician. Order any spare parts you
may need with your local dealer.
VDL10DL
2
VELLEMAN