Battery Charger - CBE CB516/24V Bedienungsanleitung

Fig.1 - DIMENSIONS (mm):
85
IMPORTANT: - The installation of this device must be carried out by specialized technicians.-

BATTERY CHARGER

- Install the battery charger in an appropriate housing, dry and ventilated; maximum efficiency
can be obtained when the battery charger is installed in vertical position (see figure 2), keeping
the front side at minimum distance of 300 mm and the bottom and top side at a minimum
distance of 100 mm from the housing sides.
- Do not cover air intakes.
- To guarantee a proper change of air the installation of two air intakes (one placed on the top
and one on the bottom, see figure 2) ensuring a working temperature inside the housing not
exceeding 50 °C.
- Make sure that the 230Va.c. safety switch can be easily reached.
- The connection to power supply mains shall be made in accordance with national installation
rules.
- Before disconnecting the battery charger from 230Va.c. power supply, turn the safety switch off.
- The installation requires the fixing of no. 4 pins that can be easily placed on the 4 sides.
- The battery charger can be installed together with CBE 12V and 230V distribution panels, using
the appropriate modular joints.
CABLES
- Use cables with appropriate section, minimum cross section area 4 mm².
- Protect cables from any possible damage.
BATTERY
- Lead-acid batteries shall be positioned in a well ventilated place.
- Use only 24Vd.c. rechargeable lead batteries (capacity >40Ah).
GB
Warning:
- Do not use "not rechargeable" batteries.
- Exhausted batteries shall be disposed in accordance with existing environmental protection
8
regulations.
157
110
140
- Caution, do not connect the battery charger:
1 when a generator set with non stabilised output voltage is employed
1 with power mains voltage exceeding the rated value (230Va.c. ±10%)
- Do not carry out any maintenance when the battery charger is connected to the
230Va.c. power supply net.
- In case of battery charger's misuse, the guarantee falls off and the manufacturer
declines all responsibility for damages to people and things.
Fig.2 - VERTICAL INSTALLATION