Rear Side - AER MM 200 Bedienungsanleitung

The Acoustic People
gnd 9 V
lift
phantom
power
gnd 9 V level
lift
3
1 2
phantom
power

3.2 Rear side

1) gnd lift: Signal ground/protective ground
disconnecting switch to prevent hum caused
by ground-loops: off = not pressed.
2) 9 V phantom power: On/off-switch for 9 Volt
phantom power (channel 1, off = not pressed,
see para. 5.4.1 on page 8).
3) level: Aux signal level control
4) aux in L/R: Stereo input for additional signal
sources, e.g. CD-player, Cinch/RCA-sockets
(white = left channel, red = right channel).
5) footswitch: Stereo connection socket for a
double-footswitch (on-/off-switch, tip = inter-
nal effect/ring = external effect on/off).
6) tuner: The tuner output supplies a pre-master
signal (mono jack socket, -10 dbV) to connect an
external tuner to the MM 200.
7) line out: The line out supplies a pre-amp signal
taken after tone-control, effects and master for
forwarding to other appliances.
12
level aux in footswitch
L
L
R
R
tip = int. e .
ring = ext. e .
aux in footswitch tuner
5
L
L
4
R
R
tip = int. e .
ring = ext. e .
tuner line out level
line out level
6 7 8
8) level: DI-signal level control
9) DI-out: Preamp-output (XLR male socket) with
symmetrical signal, after tone-control, pre
master, without effects.
10) send: Send is an output (mono jack socket)
to connect the MM 200 to an external effect
device and in conjunction with return (input)
forms a loop here designed as external effect
loop. The effect can be switched on or off via
footswitch.
11) return: Return (mono jack socket) as part of
the effect loop operates as signal input from an
external effect device (from output of the effect
device). The effect can be switched on or off via
footswitch. Return on its own can also be used
as quasi auxiliary signal input (-10 dbV).
12) headphones: This output enables you to con-
nect stereo headphones and mutes the louds-
peaker. !!! Warning: Only use headphones
with stereo jackplugs in this output socket!!
13) power on: Combined mains switch with mains
socket and fuse holder to switch the MM 200
on or off.
DI-out send return
DI-out send return
9
10
headphones
headphones
12
11
13