Dust Cover Fitting; Connection To Amplifier; Phono-Input; Connection To Power Supply - Dual CS 418 Betriebsanleitung

Dust cover
1. Slot both hinges (2) into the housings (3) in the back of the turntable.
2. Uniformly push the right and left dust cover (1) receptacles onto the hinges

Connection to Amplifier

The turntable comes with a built-in phono pre-amplifier. It can be either connected to the phono input or the line input at the amplifier.
The built-in phono stage can switched on or off via a switch in the back of the turntable.

Phono-Input

1. Connect the RCA cable to the Audio output „AUDIO OUT" (2) at the turntable
and the PHONO input sockets at the amplifier.
2. Move the switch (1) into the position: PHONO.
3. Connect the ground connection GND (3) with the amplifier to avoid noise.
Note:
Ensure the correct connection of the cable.
(red = right channel, white = left channel)
Line-Input
1. Connect the RCA cable to the Audio output „AUDIO OUT" (2) at the turntable
and the LINE / AUX input sockets at the amplifier.
2. Move the switch (1) into the position: LINE.
3. Connect the ground connection GND (3) with the amplifier to avoid noise.
Note:
Ensure the correct connection of the cable.
(red = right channel, white = left channel)

Connection to Power Supply

Different adapter plugs (1) are included with the product. Find the specific adapter
relevant to your country and socket system. Fit it to the power supply (2).
1. Fit the socket adapter into the power supply (A) and twist in the direction
of the arrow.
2. Check that the adapter is locked correctly (B) and the markings match up (C).
3. Connect the output cable of the power supply with the DC IN (3) socket of the
turntable.
4. Plug the power supply into a power socket.
Note:
Only use a factory supplied or approved power supply.
Damage to the turntable!
Incorrect voltages can damage the product. Ensure that the
mains voltage is within the stated specification.
Set Up
C
3
19