Programming the radio control
A) Insert the Key-block code on the Twin transmitter.
(see instructions on following pages)
B) Power up the receiver RE432TW;
C) Keep the code-saving key pressed (Fig. 1: the LED indicator will fl ash) and send the
code by pressing any transmitter key (Fig. 2: the LED indicator will remain on to indicate
that the code has been saved).
Carry out the same procedure for the other memorisation key.
N.B.: if the code needs to be changed, repeat the sequence described.
Fig. 1
4
Fig. 2
CH1=OUT1
CH2=OUT2