Hazet SmartTAC SYSTEM 7000-5 sTAC Betriebsanleitung Seite 30

9 . Adjustment / calibration
Electronic torque wrenches with built-in angle gauge should be
checked and calibrated on a regular basis. After a long period of
use, re-certification or re-calibration by the factory is advisable.
Electronic torque wrenches with built-in angle gauge are measur-
ing tools. Appropriate measurement equipment must be used to
test (and where applicable, adjust) measuring tools at the time
intervals laid down by Quality Management.
The time gap between test dates is dependent on the frequency
of use. We recommend testing after approx. 5000 screw opera-
tions (but the period in-between tests should be no longer than
6 months).
NOTE! The "Version" menu option provides information
on the software version, the serial number, the date of
the last calibration and the remaining number of
releases until the next calibration of the wrench.
1. To access the information in the "Version" menu option,
you must switch to the menu with
"Version" menu option with
2. The software version information is displayed after press-
ing in the "Version" menu option.
3. Further information is shown on the second page of the
display. Use to move to the 2nd screen and
return to the 1st.
HAZET has appropriate test equipment. HAZET torque wrenches
with built-in angle gauge sent in to HAZET are returned with a test
certificate after they are checked and after any necessary adjust-
ment/calibration work is carried out. The test equipment used by
HAZET for torque wrenches with built-in angle gauge is continu-
ally monitored by the German Calibration Service (DKD) and is
calibrated and adjusted whenever required. This guarantees both
the level of expertise necessary in the field of controlled screw
joint tightening and also the quality of HAZET tools.
The HAZET factory also accepts electronic torque wrenches with
built-in angle gauge from your specialist dealer for inspection
and calibration.
30

Design and function
and select the
.
to
10 . Torque wrench with built-in angle
gauge certificate and calibration
instructions
Every torque wrench with built-in angle gauge comes with a qual-
ity test certificate in compliance with DIN 55350-18-4.2.2.
Please contact your HAZET partner if you lose the certificate or
require calibration instructions.
11 . Accessories
A comprehensive range
ries is available for all HAZET torque/angle wrench-
es. Please refer to the HAZET tool catalogue or visit:
www.hazet.de or hazet.com
of quality accesso-