Life & Mobility Mezzo 3 Gebrauchsanweisung Seite 31

Settings and adjustments
Armrests
Attention:
ƒ The position of the armrests changes if the
position of the backrest is adjusted.
1. Rotate the armrest upwards to the desired
angle.
2. Rotate the adjusting wheel (N) to lock the
angle of the armrest.
3. Loosen the adjusting wheel (N) to move the
armrest down.
Backrest lumbar support
1. Turn the button (K) once at a time.
This changes the curve of the backrest.
2. Check if the new setting has the desired
result.
There are 3 positions.
Adjusting the handlebars
Be careful:
ƒ Do not pull the handlebars upwards too
firmly when adjusting; the maximum setting is
8 cm.
Attention:
Have your dealer set the handlebar height in
ƒ
the correct position once and for all before
using the mobility scooter.
Do not adjust the angle of the steering
ƒ
column while driving. A gas spring allows the
handlebars to move forward independently.
Handlebar height
1. Loosen the (socket) screw (R) using an Allen
key.
2. Adjust the height of the handlebars.
3. Tighten the screw again firmly.
GB22
N
Change armrest angle
K
Set backrest lumbar support
R
Set handlebar height
T
Change handlebar angle
Settings and adjustments
Steering column angle
1. Sit down on the seat.
2. Squeeze the lever (T)*.
3. Pull the steering column towards you or push
it away until you reach the desired position.
4. Release the lever.
The steering column is now locked in place.
* It is located on the left or right­hand side,
depending on the configuration of your
mobility scooter.
GB23