Troubleshooting - Hendi 211403 Gebrauchsanweisung

Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning & storage.
Cleaning
• Clean the appliance before and after each use.
• Never immerse the appliance in water or other
liquids.
• Do not clean the appliance with a water jet.
• Flush the tap and the liquid level indicator thor-
oughly.
• Clean the surface with a slightly damp cloth or
sponge with some mild soap solution.
Descaling
• Hard water may cause some deposits to form in-
side the container and cause possibly damage to
the appliance.
• Thus, descale the appliance regularly. The des-
caling intervals depend on water hardness and
frequency of use. Use only commercially availa-
ble descaling agents and follow the instructions
of the manufacturer.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.

Troubleshooting

If the appliance does function properly, please check the below table for the solution. If you are still unable to
solve the problem, please contact the supplier/service provider.
Defect Problem
Appliance does not Neither green on/off
work at all. light nor indicator light
is illuminated.
Boiler switches off The orange light is il-
automatically. luminated.
Boiler does not Green light is not
reach the selected illuminated.
temperature.
Cause
No mains power.
Boiler has exceeded maxi-
mum safety limits. Dry boil-
ing protection is activated.
Thermostat does not work.
Heating element does not
work.
When in doubt always contact your supplier!
• All washed parts should be rinsed with clean wa-
ter to remove the cleaning residues.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
- Fill the container with water and appropriate
amount of descaling agent up to MAX level.
- Start boiling the solution.
- After boiling, dispose of the solution of water
and descaling agent properly.
• Rinse the container and boil twice to remove any
residues.
• Store the appliance in a cool, clean and dry place.
Possible solution
Check the electrical con-
nections.
Unplug & let it cool down
for 15 ~ 20 minutes. Then,
plug it and restart again.
Contact your supplier.
EN
7