Hendi 211403 Gebrauchsanweisung Seite 6

Preparations before first use
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages, DO
NOT use the appliance. Please contact supplier
(See ==> Warranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
Use
• Make sure the tap is closed.
• Fill the appliance with beverage up to the MAX
level indicated on the liquid level indicator (5).
• Close the boiler with the lid.
• Switch the appliance on by setting the switch to
position I. The green switch light will be on (fig. 1).
• Use the temperature dial (11) to select the de-
sired temperature (maximum temperature set-
ting is 110 °C). The actual temperature can differ
from the selected temperature.
EN
After use / Empty the boiler
• Turn off the appliance by switching off the switch
and removing the plug from the socket.
• Place a drip tray under the tap.
6
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 20 cm around the appli-
ance.
• Keep the packaging if you intend to store your ap-
pliance in the future.
Note: Due to manufacturing process, the appliance
may emit a slight odor and smoke in the first
few cycles. This is normal and does not indi-
cate any defect or hazard. Discard the water
from the first few cycles to remove any resi-
dues from the manufacturing process.
• When heating is in progress no light will be indi-
cated (fig. 2).
• When the beverage has reached the selected
temperature, the green indication light will be
illuminated (fig. 2).
• When dry boiling protection is activated or the
boiler is too hot, the "dry boiling protection" indi-
cator will light on in orange colour (fig. 2). Unplug
it & let it cool down completely for 15 ~ 20 min-
utes. Then, plug it and restart again.
fig. 2
fig. 1
• Open the tap and drain the beverage out of the
boiler.
• When the boiler has been emptied, close the tap.