Stand-Alone Mode - EuroLite LED IP T-Bar 16 QCL Bar Bedienungsanleitung

Stand-alone mode

Preset colors
In the Stat mode the device will constantly emit one of 19 preset colors.
1 Press the MENU button so many times until Stat is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired color. Confirm with the ENTER button.
Automatic mode
In automatic mode, 9 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program (01 – 09). Confirm with the
ENTER button.
2 Press the MENU button so many times until SPEE is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from 01 (slow) to 09
(fast). Confirm with the ENTER button.
Color mix
In Colo mode each of the 4 colors can be individually adjusted in intensity. The device will then constantly
emit the chosen color setting.
1 Press the MENU so many times until Colo is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates the letter R for the color red and the corresponding intensity value. Use the
buttons UP and DOWN to adjust the desired intensity.
3 Confirm with the ENTER button. Now the color green can be set; then blue and then white until the
desired color intensity is achieved.
Total brightness
The menu point dIMM allows adjusting the total brightness for all stand-alone operating modes: Stat, Auto
and Colo.
1 Press the MENU button so many times until dIMM is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired brightness (dl 1 = dark, dl 9 = bright). Confirm with
the ENTER button.
Fading program
In FADING mode the speed for fading can be set.
1 Press the MENU button so many times until FAdE is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired speed (FA 0-9). Confirm with the ENTER button.
Strobe effect
In FLAS mode the speed for strobe effect can be set.
1 Press the MENU button so many times until FLAS is indicated in the display Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired speed (FL 0-9). Confirm with the ENTER button.
24/32 00129165, Version 1.0