Main Modes; Controlling Temperature - Sharp SJ-WX830A Bedienungsanleitung

Main modes

Controlling temperature

• The refrigerator controls its temperature automatically.
You can set the preset temperature as below.
• See "Multi temperature room" about the preset
temperature of multi temperature room.
Refrigerator
• Default setting is 3°C.
• You can adjust between 0°C and 6°C in step of 1°C.
1
Press enter key.
2
Select the
compartment.
The compartments change in the order shown as on
the picture by pressing this key.
→
3
Decrease Increase
Set the temperature.
4
Press enter key.
Freezer
• Default setting is -18°C.
• You can adjust between -13°C and -21°C in step of 1°C.
1
Press enter key.
2
Select the
compartment.
The compartments change in the order shown as on
the picture by pressing this key.
→
EN-7
Current setting
→ →
Current setting
→ →
3
Decrease Increase
or
Set the temperature.
4
Press enter key.
• You can adjust the temperature in steps of 0.5°C in the
following way at procedure 3.
E.g. Refrigerator
3
Decrease
Increase
Set the temperature.
Set the
temperature
again.
Note
• The temperature that indicated on the control panel
is not the exact temperature inside.
•
factors as the location of the refrigerator, ambient
temperature and the frequency of door opening.
Temperature rise sign
If the inside temperature becomes as follows, this sign
lights up.
• Check the quality of food before you eat.
• This sign may light up at start of power supply.
lighted compartment of compartment select key when
this sign is ON.