Mounting The Pump-Container Unit; Dismounting The Pump-Container Unit; Filling Electrolyte Into The Container; Emptying The Container Of Electrolyte - struers Movipol-3 Gebrauchsanweisung

Mounting the Pump-Container
Unit
Dismounting the Pump-
Container Unit
Filling Electrolyte into the
Container
Emptying the Container of
Electrolyte
Mounting the Polishing
Chamber
8
Movipol-3
Instruction Manual
 Lower the pump-container unit into the cabinet.
 Press the unit down until a click is heard. The pump-container
unit is now locked in the cabinet.
 Press the two black locks to the sides from the pump in direction
of the cabinet wall, a click is heard and the pump-container unit
is dismounted and can be removed from the cabinet.
 Before filling electrolyte into the container, the section, Safety
Precautions should be carefully observed.
 Remove the pump and container from the cabinet.
 Remove the pump from the electrolyte container.
 Pour the electrolyte into the electrolyte container. The level must
be between the minimum (350 ml) and maximum (750 ml)
marks.
 Mount the container on the pump and mount the unit in the
cabinet of Movipol-3.
 Before emptying the container of electrolyte, the section, Safety
Precautions should be carefully observed.
 Remove the pump-container unit from the cabinet and remove
the container.
 If the electrolyte is to be used again pour the electrolyte carefully
back into the electrolyte bottle. Use the funnel supplied with the
apparatus.
 If the electrolyte is not to be used again it should be filled into a
container suitable for disposal. Please observe the local
regulations and instructions for disposal.
Funnel, gloves, ventilation as well as all other prescribed equipment must be
 Press the polishing chamber onto the pencil until it fits tightly.
A polishing chamber has a limited lifetime as the plastic hardens
because of contact with the electrolyte. The chamber should be
renewed regularly.
IMPORTANT
used during filling/emptying.