What You Will Receive With The Bandsaw; Locating Your Bandsaw; Locking The Bandsaw - IGM LAGUNA 14BX Gebrauchsanweisung

Location of warning signs
Fence
Pic. 8
Table ratchet handles & washers
Pic. 10 Fence guide bar attachment parts
Table
www.igmtools.com
Pic. 7
Fence guide bar
Pic. 9
Rubber feet and fixings
T bar
-6-
Your bandsaw will be shipped in custom
packaging consisting of a heavy-duty cardboard
box and Styrofoam internal packaging.
1. Open the cardboard box and remove the
loose parts and top Styrofoam.
2. Lift the bandsaw out of the packaging. You
will need two or more people, as the bandsaw
is heavy.
3. Lift the bottom Styrofoam out and remove the
parts that are packaged under the
bandsaw and packaging.

5.3 What you will receive with the bandsaw

• Ruler and table assembly aids
(Figure 8, 9, 10).

5.4 Locating your bandsaw

Before you remove your bandsaw from the pallet,
select the area where you will use your machine.
There are no hard-and-fast rules for its location,
but below are a few guidelines.
1. There should be an area at the front and back
of the machine suitable for the length of wood
that you will be cutting. If you intend to use your
saw for scrollwork, this may not be important but
should be considered at this stage.
2. Adequate lighting. The better the lighting, the
more accurate and safely you will be able to work
3. Solid floor. You should select a solid, flat floor,
preferably concrete or something
similar.
4. Close to power source and dust collection.

5.5 Locking the bandsaw

It is strongly recommended that the bandsaw is
never be left unattended in the unlocked
condition.
To lock the machine it is recommended that a
cover (not supplied) is made to lock the control
panel. We have supplied two concepts for locking