Grundig SIS 9870 Bedienungsanleitung Seite 33

TROUBLESHOOTING __________________________
Problem
The base does not heat
although the appliance is
plugged.
The appliance does not pro-
duce steam.
Water droplets drip on the
cloth.
Sediments and residues fall
of from the base
ironing.
There are stains on the base
.
K
The on/off button
appliance flashes.
The " " symbol flashes
on the control panel
Possible cause
There may be a problem with
K
the connection.
The amount of water in the
water reservoir may be inad-
equate.
Water may come out when
you press the steam trig-
ger before the appliance
C
reaches the set temperature.
Such sediments may occur
while if the water you use in your
K
appliance is too calcareous.
Wet clothes are ironed / scale
stains have occurred on the
base .
K
The appliance may have
of the
D
switched to auto off mode.
The time for descaling has
. come.
A
Solution
Check the plug and the power cord of
the appliance
Press the on/off button
Contact the authorized service if the
appliance does not operate although
the appliance is plugged and you
have pressed the on/off button.
Fill the water up to the MAX line in the
water reservoir.
Check if the water reservoir
stalled in its housing.
The appliance does not provide steam
if the temperature is set to "•" posi-
tion. Bring the temperature setting to
"••", "•••" or "MAX" position.
When the iron is being prepared
symbol " " in the control panel
turns off completely, your appliance is
ready for ironing.
Fill the water reservoir of the appli-
ance by mixing the tap water and
drinking water for your next ironing
operations.
Wipe the sediments and residues with
a lightly dampened cloth after the ap-
pliance is cooled down adequately.
Press the on/off button
Perform the descaling operation.
.
D
is in-
H
A
.
D
ENGLISH 33