Cutting Height; Clip Director - Honda HRX537VYE Bedienungsanleitung

Removal
1. Raise the discharge guard, grasp the grass catcher handle, and
remove the grass catcher.
2. Release the discharge guard.
3. When the grass catcher is clear of the discharge guard, you can lift
it through the handlebar opening, or you can remove it to the rear
of the mower below the handlebar.

Cutting Height

Check the mower deck cutting
height settings, and be sure
that all four adjustment levers
[1] are set to the same cutting
height position.
To adjust
[1]
cutting height,
pull each
adjustment
lever [1] toward
the wheel, and
move it into
another notch.
If you are not
sure what
cutting height to
select, start
with a high
setting and
check the
appearance of
the lawn after
mowing a small
area. Then
readjust cutting
height if necessary.
Rear Shield
During normal use the rear shield [3] is subject to deterioration and
wear. Remove the grass catcher [1] and raise the discharge guard [2]
to check the rear shield for cracks or tears. If the rear shield is
excessively worn, have it replaced by your authorized Honda
servicing dealer.
[2]
8

Clip Director

Clip Director Knob Adjustment
Adjust the Clip Director knob [1] in any one of the ten positions to
achieve the desired mowing results.
To adjust the Clip Director knob, pull the knob downward and towards
the rear of the mower. The knob adjusts a sliding door [2] from the
fully open BAG position to the fully closed MULCH position (see the
following page).
[1]
19 mm
32 mm
If a high resistance is noticed when moving the Clip Director knob
45 mm
from side-to-side, excessive grass may have built up on top of the
sliding door.
62 mm
Some grass accumulation in the discharge opening is normal when
75 mm
the Clip Director is fully closed. To remove this grass, close the
discharge guard [3], fully open the Clip Director, start the engine, and
88 mm
engage the cutting means control lever several times.
101 mm
Important Safety Precaution
Always turn the engine off and disconnect the spark plug cap before
lifting the discharge guard to view or clean around the sliding door.
This will prevent contact with the rotating cutting means and prevent
objects from being thrown into the discharge area.
Some grass accumulation in the discharge opening is normal when
the Clip Director is fully closed. To remove this grass, close the
discharge guard, fully open the Clip Director, and start the engine.
If a high resistance is noticed when moving the Clip Director knob
from side-to-side, excessive grass may have built up on top of the
sliding door.
[1]
[3]
ENGLISH
[1]
[2] (fully closed)