Operation; Turning The Scale On/Off; Weighing Mode; Enter The Mode And Start Weighing - OHAUS i-DT61PW Bedienungsanleitung

EN-16

3. OPERATION

3.1

Turning the Scale On/Off

To turn the scale on, press and hold the On/Zero Off button for 1 second. The scale performs a display test,
momentarily displays the software version, and then enters the active weighing mode.
To turn the scale off, press and hold the On/Zero Off button until
3.2

Weighing Mode

Use this application to determine the weight of items in the selected unit of measure. This mode is the factory
default setting.

3.2.1 Enter the Mode and Start Weighing

To enter the weighing mode from any application mode:
Press and hold the Mode button until
1.
2. If needed, place an empty container on the pan and press the
3. Add sample to the pan or container. The display shows the weight of the sample.
Note: Please refer to the Check section for how to use Check in the Weighing mode.

3.2.2 Accumulation and Statistics

The Accumulation feature enables manual or automatic totalizing of displayed values. Statistical data (total
accumulated weight, min/max weights, pieces, percent, and total number of samples) is stored in memory for
review and printing. Accumulation works together with each application mode except Filling, but the
accumulation data will be cleared when change to another mode.
3.2.2.1 Settings
There are four accumulation options:
OFF
Off ( ):
mMANU
Manual ( ):
AUtO
Auto ( ):
ACCEPt
Accept ( ):
To set accumulation options:
1. Long press the Menu button until you see
Short Press the No button one time. When you see
2.
3. Short Press the No button several times to navigate until you see
4. Short Press the No button several times to select the accumulation option you want. The four options have
been introduced above. Then press the Yes button to confirm.
Press the Exit button to exit.
5.
3.2.2.2 Accumulation
Manual
Place the item on the scale and press the M+ button to add the weight to accumulation. The ∑ pointer will keep
flashing until the weight is removed and the platform is stable.
Auto
Place the item on the scale. The displayed value is accumulated automatically. The ∑ pointer will keep flashing
until the weight is removed and the platform is stable.
Accept
Place the item on the scale in check mode. The displayed value is accumulated automatically when the weight
is acceptable between the under and over value you set.
3.2.2.3 Viewing and Clearing Statistical Data
When the pan is cleared, press the M+ button to view the accumulation and statistics results.
To clear the accumulation data, press the CLR button on i-DT61XWE terminal or the
DT61PW terminal while the statistical information is displayed. When the display shows
wWeIGH
disable accumulation function.
press the M+ button to do acuumulation manually.
the scale will perform accumulation automatically.
the scale will perform accumulation automatically in the Check mode when the weight
on the pan is acceptable between the under and over value you set.
OFF
is displayed.
C.A.L
.
S.E.t.U.P
, press the Yes button.
Defender 6000 Indicators
is displayed.
button to tare.
ACCUmM
. Press the Yes button.
button on i-
Clr.aCC
, press the