Equipment With Mts System (Multi-Transmitter System) - ELCA MAGO Betriebsanleitung

ENG man MAGO-EVO 03 MAGO-EVO Radio Remote Control
2 conditions (1 - 2) function.
- When the system is switched on, condition 1 associated with the activation of LED 1 on the transmitter and the activation
of the P/EN relay output is active.
Pressing button G activates condition 2 associated with the activation of LED 2 on the transmitter and the activation of
relay G.
Pressing button G again reactivates condition 1.
Switching off the transmitter, the outputs are disabled but the next time the system is switched on again it will be in the
same condition as when it was switched off.
WARNING: if the receiver is switched off, when switched on again the system always starts in condition 1.
3 conditions (1+2, 1, 2) function.
- When the system is switched on, condition 1+2 associated to the activation of LEDs 1 and 2 on the transmitter is active
while the relays G and P/EN on the receiver are off.
Pressing button G activates condition 1 associated with the activation of LED 1 and the activation of relay P/EN on the
receiver.
Pressing button G activates condition 2 associated with the activation of LED 2 and the activation of relay G on the
receiver.
Pressing button G again reactivates condition 1+2.
Switching off the transmitter, the outputs are disabled but the next time the system is switched on again it will be in the
same condition as when it was switched off.
WARNING: if the receiver is switched off, when switched on again the system always starts in condition 1+2.
"COMMAND" BUTTONS, 6 buttons arranged on the first three rows, starting from the top (third type).
The first step of these buttons is interlocked with respect to the command of the button on the side of the same line.
Therefore the interlocked commands are A with B, C with D, E with F.
EXAMPLE: pressing buttons A and then B, only the command of the first button pressed is transmitted, i.e. A.
The second step of the button on the same row activates the same command.
Example: the second step of buttons A and B activates command I.

4.2 EQUIPMENT WITH MTS SYSTEM (MULTI-TRANSMITTER SYSTEM)

The devices of the series MAGO with MTS (Multi-Transmitter System) enable multiple transmitters MAGO-EVO to
command the same receiver. All transmitters that compose the system are enabled to control the receiver, but only one
at a time exclusively and uniquely determined.
To the same receiving unit that is part of the MTS system you can match from a minimum of two up to a maximum of 15
transmitter units, these latter are identified by "Unit n.1" up to "Unit n.15". The identification of the transmitter is shown in
the data label near the serial number
When powered, the receiving unit is in free state and can be engaged by the first transmitting unit that performs the
enabling sequence. From this point on, the transmitter unit that takes control commands exclusively the receiver and no
other transmitter unit can take over or interfere with the operation.
To free up the receiving unit it is mandatory that the transmitter, which had taken over the command, performs the
operation of voluntary release by pressing and holding down the START button and by pressing twice E button. The
release is indicated by the turning off of the receiver and the transmitter.
Free again, the receiver is ready to be controlled by any other matched transmitter that performs the enabling sequence.
- Page 11 -