Cancellation (Erasing) - ELCA MAGO Betriebsanleitung

ENG man MAGO-EVO 03

7.4 CANCELLATION (ERASING)

This procedure deletes all memorized coupling data within the transmitter which prepares the transmitter for a new
coupling procedure.
Attention: with this procedure the receiver which is coupled with the transmitter is no longer controllable (unless a new
coupling procedure is done) and all the settings made by the user in the transmitter will be reset to factory settings.
Verify that the transmitter is OFF and the mushroom STOP released.
G
START
G
START
A
I
B
I
B
I
G
START
Once completed the coupling data within the Transmitter will have been cancelled.
Now it is possible to use this Transmitter to effect a new COUPLING procedure wparagr.7.2.
Simultaneously press together the fi rst step
of the G button with the START button until
the Red LED stops fl ashing and the Green
LED fl ashes 1 fl ash per second.
Insert the PIN CODE
The default PIN CODE is START, G, START,
START
unless the operator has registered a personal
code.
Fixed White LED 1 will light up.
Green LED fl ashes.
Press A button repeatedly until you see the
fi xed White LED 3 light up.
Green LED fl ashes.
Press B button to access the ERASING
Menu. You should see White LED 1 fl ashing.
Green LED fl ashes.
Press simultaneously the G,START and B
buttons until you see the Green LED fi xed
which confi rms the Cancellation has been
done.
- Page 17 -
MAGO-EVO Radio Remote Control
STOP
A
B
I
I
C D
L L
E F
N N
G
START