Programmable Functions - ELCA MAGO Betriebsanleitung

ENG man MAGO-EVO 03
- INPUTS FROM RECEIVER INDICATOR: white LEDs numbered from 1 to 4; these can be used to signal the
status of the inputs arranged for this purpose on the receiver. The LEDs already set to indicate the status of
button G can not be used for this indication.

2.4 PROGRAMMABLE FUNCTIONS

The MAGO radio remote control system allows the user to program some of its functions including:
- ACTIVATION/DEACTIVATION OF THE DEFAULT ENABLING SEQUENCE
- SETTING OF THE PERSONALISED ENABLING SEQUENCE
- TIMING OF THE AUTO SWITCH OFF
WARNING!
Perform programming when one has acquired a minimum of familiarity with the system. Logging into the programming
menu when not fully understanding the exact procedures can lead to the unwanted programming of functions.
ACCESS TO THE PROGRAMMING MENU.
1) Simultaneously press the first step of the START and G buttons until the blinking red LED (2 blinks per second)
switches to the blinking green LED (2 blinks per second).
2) Press the enabling sequence (default is Start, G, Start). The green LED continues to blink, but the white LED 1 is
steady.
Warning! The menu closes without saving the changes after 10 seconds of inactivity or by pressing the mushroom Stop
button.
ACTIVATION/DEACTIVATION OF THE DEFAULT ENABLING SEQUENCE.
Open the programming menu (see ACCESS TO THE PROGRAMMING MENU)
1) Press button B: the green LED blinks twice per second.
2) Now press button A to disable (white LED 1 blinking) or enable (white LED 2 blinking) the default enabling sequence.
3) Confirm the programming by simultaneously pressing buttons G, START and B for a few seconds.
SETTING OF THE PERSONALISED ENABLING SEQUENCE.
Open the programming menu (see ACCESS TO THE PROGRAMMING MENU)
1) Press button A until the white LED 2 remains steady on and the green LED blinks.
2) Press the sequence of buttons you want to set as an enabling sequence. White LEDs 1, 2 and 3 light in sequence.
3) Confirm the programming by simultaneously pressing buttons G, START and B for a few seconds.
Note:
If you want to define an enabling sequence for a single button, press the Start button as the first and third button of the
sequence. If you want to define an enabling sequence for a two buttons, press the Start button as the first or the third
button of the sequence.
TIMING OF THE AUTO SWITCH OFF.
Open the programming menu (see ACCESS TO THE PROGRAMMING MENU)
1) Press button A until the white LEDs 1 and 2 remains on and the green LED blinks.
2) Press button B to access the menu. The white LEDs begin to blink indicating the current selection.
3) Now press button A to select the desired setting:
- LED 1 blinking, Auto Switch-Off Disabled
- LED 2 blinking, Auto Switch-Off in 2 minutes
- LEDs 1 and 2 blinking, Auto Switch-Off in 5 minutes (default value)
- LED 3 blinking, Auto Switch-Off in 10 minutes
4) Simultaneously press buttons G, START and B for a few seconds to confirm programming.
- Page 5 -
MAGO-EVO Radio Remote Control