Troubleshooting; Technical Data - Lupine Betty R Bedienungsanleitung

Troubleshooting

Problem Cause
The light does not come on Extremely discharged battery.
and the power LEDs do not
flash when the battery is
plugged into the lamp.
Battery not plugged into the
light or not plugged in
properly.
With the battery plugged in, Faulty LED unit.
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on Discharged battery.
for as long as they should. Old battery.
Very low ambient
temperature.
Faulty charger.
Unsuitable battery.
Even after charging only The indicator was reseted.
the 20% LED will light up
at the Smartcore battery.
The lamp does not recognize Lamphead and transmitter
the transmitter. are not linked.
The transmitter does not light up
Button cell empty or
while pressing the button and the
wrong side up.
lamp does not react.
4 0
Solution
 Charge the battery. Before
doing so be SURE to read
the "Battery cannot be
charged" section below.
 Check all plug contacts.
 Replace the LED unit.
 Charge battery.
 Replace battery.
 Keep battery warm.
 Replace charger.
 Use original Lupine battery.
 Discharge the battery with
your light and fully charge it
afterwards.
 See chapter operation
remote control.
 See chapter operation
remote control.
Light output: Battery life:
Betty with 6.9Ah battery:
1 h
45 W 5400 lumen
1 h 25 min.
34 W 4200 lumen
28 W 3600 lumen 1 h 45 min.
22 W 3050 lumen 2 h 10 min.
16 W 2200 lumen 3 h
12 W 1700 lumen 4 h
8 W 1200 lumen 6 h
4 W 650 lumen 12 h
24 h
2 W 330 lumen
48 h
1 W 170 lumen
0.3 W 50 lumen 150 h
Runtime varies according to battery age and condition, as well as ambient temperature.
Ladegerät Charger One:
Input voltage: 12 – 14 V =,>= 2 A from power
supply or 12 V charging cable
Charging current: up to 2.5 A
Discharge current: up to 0.5 A
Compatible batteries: Li-Ion 7.2 V
Display: illuminated two-line 16
character display
Terminals: polarity-protected input and
output terminals
Battery capacity; nominal voltage:
Betty with 6.9Ah battery: 6.9 Ah 7.2 V Li-Ion
Betty with 13.8Ah battery: 13.8 Ah 7.2 V LiIon
Hereby, Lupine lighting systems GmbH declares that the radio equipment type Bluetooth remote control V2
is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: https://www.lupine.de/documents/ce

Technical data

Betty with 13.8Ah battery:
2 h
2 h 45 min.
3 h 20 min
4 h 20 min.
6 h
7 h 30 min.
12 h
24 h
48 h
96 h
310 h
Default setting
Charging time:
Betty with 6.9Ah battery: 2 h 45 min.
Betty with 13.8Ah battery: 5 h 30 min.
Lens beam angle:
26°
Operating temperature:
-25 °C – +70 °C
41