Lupine BETTY R Bedienungsanleitung Seite 20

Special functions
Adjusting the low-battery warning LEDs:
Use this program to adjust the onset of the low-battery warning.
1.
Press and hold the button for until 4 green
release the button.

2.
The threshold can be selected as shown below.
Lamps backlight and remote: red
6.2 V
6.4 V
Factory setting
6.6 V
6.9 V
7.1 V
Recover factory settings:
1.
Press and hold the button until 5 red
release the button.

2.
Disconnect the battery, and all factory settings will be restored.
3 8
LEDs light up.
red
blinking
5.8 V
6.0 V
6.2 V
6.5 V
6.8 V
LEDs turn on.
Charger One:
Before seriously using your flashlight for the first time, the battery requires
charging. For this purpose, please unscrew the battery tank from the flashlight
head. The charging socket is located on top of the battery. You can either use
the Charger One with the power adapter or the 12 V charging cable.
The Charger One comes with four different charging modes. At the
push of the button you can switch between these.
1. Li-Ion "charging" mode (standard)
The Charger One automatically stops the charging process.
The display will show "Full".
2. Li-Ion "discharge" mode
In order to discharge the battery. The display will show you the
discharged capacity.
Attention: Do not store an emtpy battery!!!
3. Li-Ion "discharge/charge" mode
This mode gives you the possibilty to discharge and charge the
battery in one go. The program can be used after recalibrating a
Smartcore battery.
4. Li-Ion "50% storage" mode
With this program the battery will be charged to 50% of the ca-
pacity. This is perfect for storing the battery over a longer period
of time.
Battery voltage in Volt (V) Current in amperes (A)
 Warning! This charger is to be used to charge rechargeable Li-Ion
batteries only. It is NOT suitable for charging NiMH batteries!
 Do NOT use non-rechargeable batteries. – Risk of explosion!
Charger One
Charged in capacity in Ah
39