Lupine BETTY R Bedienungsanleitung Seite 18

Customizing the brightness levels
You have the option to setup to 4 brightness levels, in any sequence
1.
Press and hold the button until one green
release the button

2.
The range of brightness levels you can select will begin
automatically to cycle, as shown below.
3.
Press the button at the brightness level you want.
the first power-on click is presented

4.
Upon releasing the button, the sequence
of brightness levels automatically
restarts, allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
Note: All changes to the light can also be made
by the free Light Control App for IOS and And-
roid. With the App it is also possible to remote
control the light and the status monitor offers
additional informations.
3 4
LED lights up.
1 W
brightness level
2 W
brightness level
4 W
brightness level
8 W
brightness level
12 W
brightness level
16 W
brightness level
22 W
brightness level
28 W
brightness level
34 W
brightness level
45 W
brightness level
SOS*
RVLR*
Alpine SOS*
Flash*
0.3W Center-LED **
Default setting
* If in use, shown by green LED
** Will not be signalised by status LED
With red LED 0.8W
Recover factory settings:
1.
Press and hold the button until 5 red
release the button

2.
Disconnect the battery, and all factory settings will be restored.
3.
Reconnect the transmitter with the lamphead see page 39.
SOS:
SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
RVLR:
This mode includes an additional slow flash mode.
Alpine SOS:
Alpine SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
Flash 15hz: (Disorientation)
This mode is extremely irritating and may by no means be misused.
Center:
Low beam made by the center LED only.
LEDs turn on.
35