Sentiotec VitaMy 164 Montage- Und Gebrauchsanweisungen Seite 12

Instructions for installation and use
Wall element installation
Begin the installation of the wall elements with Wall Elements W2 and W3 or W4
and W5 respectively (see the chapter Layout on page 43). The wall elements
are connected with the "multi-clips" with the corner posts.
Make sure that the elements with the opening for the infrared radiators W3 and
W4 are used at the back of the cabin. The lower edge of the IR radiator cut-out
is at a height of 64 cm, with the bevel facing outwards.
Pre-install the wall elements with the corner posts on the ground and then
put these corners on the floor frame (see Fig. 5, 6 and 7)
Fig. 3: Multi-clips
p. 12/40
Corner post