Programming The Double Quantity (X 2) Pad - Panasonic NE-1037 Bedienungsanleitung

Programming the Double Quantity (x 2) Pad:

Your oven is preset at the factory to automatically double the programmed time for multiple portion heating.
This model allows you to customize the heating time and/or power level for multiple portions of your menu items.
For example, if Memory Pad 2 is set for 20 seconds at 1000 W, 40 seconds at 1000 W is set for double quantity
heating automatically. However, if your own tests have determined that the correct heating time required for two
portions is less (only 30 seconds at 1000 W), you can program as shown below.
Example: To program 30 seconds at 1000 W on double quantity of Memory Pad 2 (display must show "0")
PAD
1.
2.
3.
4.
5.
6.
NOTE: • Program the remaining Memory Pads as desired by repeating steps 1 to 6 above. You may insert up to
10 memory programs.
• When the Program indicator "
erased by pressing the Stop/Reset Pad.
NE-1037_EYG.indb 18
How to Operate
• Press the Program Pad.
Note:
• If no " " Indicator appeared on display,
"Program Lock" should be cancelled.
(See page 19)
• Press Double Quantity (x 2) Pad.
• Press the Memory Pad 2.
The pad number and the previously selected time
and power level for double quantity heating will
briefly appear in the display.
• The pad number and Stage Heating Indicator will
reappear in the display.
• Press the Power Level Pad once.
The Memory Pad number will go out.
• Press Memory Pads 3 and 0.
• Press the Program Pad again. You have completed
programming the selected Memory Pad for double
quantity heating.
• 2 seconds later, the display will confirm your
programming.
• 2 seconds later, the display will show "0".
" is blinking, the program can be cancelled and/or the pad number
- 18 -
INSTRUCTION
2020/11/25 10:37:21