Working With Uv-Polymerizates; Storage; Specific Processing Warnings; Polymerization Of Lp Materials - egger EL 1 Betriebsanleitung

4 Working with the UV-curing materials
4.1 Specific storage regulations
The materials are to be stored in a cool and dry place (at a maximum room temperature of
23 °C / 73.4 °F). Please mind that the containers are closed at any time, when not in use and
close them immediately after use. Otherwise, there might be danger of an unintentional
chemical reaction due to the action of light (curing of the material). The expiry date, when
stored adequately, is indicated on the product.
TIP: Already opened packages of lacquers or instant adhesives are recommended to be kept
in the refrigerator.
4.2 Specific processing notes
Please avoid direct skin contact with the materials. Before using them, protect your hands by
wearing gloves or using special skin protection products.
The material is to be used by authorized and trained staff only. Processing of the lacquers
should be done beneath an absorbing device (e.g. egger S/AB Timer REF 61400). Always use
the lacquering brushes for one type of lacquer only. Please adhere to the operation instruc-
tions.
Details on the disposal can be taken from our safety data sheets that can be downloaded as
PDF file from our website: www.egger-labor.com.
4.3

Polymerization of LP materials

 After filling the negative mold with LP material, which you can use duplicating gel (REF
40900ff) or transparent duplicating silicone for(REF 41000ff), please put the negative
form onto the workbench of the unit. Please adhere to the particular processing in-
structions for manufacturing ITE molds.
 Please close the unit with the light protection cover.
 Set the required polymerization time at the timer (see processing instructions for the
particular LP materials).
By pressing the "START/STOP" button, the polymerization will be started.

 As soon as the polymerization is finished, a blip will resound. The unit will switch off au-
tomatically.

Please remove the light protection cover and take the negative mold from the work-
bench for further processing.
Betriebsanleitung/Operating Manual EL 1 REF 51100/51120V03-2014-12 Seite / Page 19 von / of 24