Initial Operation And Handling; Advice For Disposal; Working With Uv-Polymerizates; Specific Storage Regulations - egger eLED.LP3 Betriebsanleitung

4.3 Advice for Disposal

The symbol on the unit means, that this unit may not be
disposed in general trash, but must be disposed accor-
ding to regional recycling guidelines for electronic de-
vices and applicable environmental and disposal rules.
For further information on disposal and recyc-
ling please contact your regional authorities or
your distributor of the unit.
5 Working with the UV-Polymerizates

5.1 Specific Storage Regulations

The materials are to be stored in a cool and dry place (see
processing instructions for the various materials). Please
mind that the containers are closed at any time, when
not in use and that they are closed immediately after use.
Otherwise, there might be danger of activating an unin-
tentional chemical reaction through the permeability of
light (curing of the material). The expiry date, applicable
when stored adequately, is indicated on the product.
TIP: We recommend keeping already opened packages
of lacquers or instant adhesives in the refrigerator.

5.2 Specific Processing Indications

Please avoid direct skin contact with the materials. Be-
fore using them protect your hands by using special skin
protection products or wearing gloves.
The materials are to be used by authorized and trained
staff only. Processing of the lacquers should be done un-
derneath a suction unit. Always use the lacquering bru-
shes for one type of lacquer only.
Details on the disposal for each product can be taken
from our material safety data sheets, which can be down-
loaded in PDF format from our website:
www.egger.online.
5.3 Lacquering with LP/H Lacquer – LP/H Lacquer
antibac
For the surface finish all at present known hard acrylate–
based otoplastic materials can be coated with LP/H la-
quer.
Using the LP/H lacquer antibac, you can protect hard
earmolds with a special antibacterial coating with high
gloss effect.
• The entire surface of the earmold always has to be
roughened with corundum paper, grit 180, (REF 40704)
first.
• Then, fix the BTE earmold onto a piece of nylon tube
(REF 97200). For an ITE earmold, the alligator clip of the
turning motor can be fixed on the opened battery door.
• Then, clean and degrease the surface carefully with
surface cleaner by using the hand-spray pump (REF
86732).
• Apply the lacquer evenly with the brush. Alternatively,
the earmold can also be immersed in a dipping jar
(REF 31400 or 31401) filled with lacquer; but do not
immerse ITE earmolds with built-in electronics or
face-plates! Then, make sure that excess lacquer is
shaken off.
• Let the lacquer dry in the light-curing unit rotating
for about 2 – 3 minutes. Afterwards the earmold is
directly ready for use.
egger eLED.LP3
13