Other Convenient Rds Functions And Adjustments; Setting The Ta Volume Level; Automatic Selection Of The Station When Using The Number Buttons; Automatic Clock Adjustment - JVC kd-g701 Bedienungsanleitung

Other convenient RDS
functions and adjustments
Automatic selection of the station
when using the number buttons
Usually when you press the number button, the
preset station is tuned in.
However, when the preset station is an RDS
station, something different will happen. If the
signals from that preset station are not sufficient
for good reception, this unit, using the AF data,
tunes in to another frequency broadcasting the
same programme as the original preset station is
broadcasting. (Programme search)
• The unit takes some time to tune in to another
station using programme search.
To activate programme search, follow the
procedure below.
• See also "Changing the general settings
(PSM)" on pages 34 and 35.
1
Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
¢ or 4
2
Press
"P(Programme)-SEARCH."
3
Turn the control dial clockwise to select
"SEARCH ON."
Now programme search is activated.
4
Press SEL (select) to finish the setting.
To cancel programme search, repeat the same
procedure and select "SEARCH OFF" in step 3
by turning the control dial counterclockwise.
to select

Setting the TA volume level

You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
• See also "Changing the general settings
(PSM)" on pages 34 and 35.
1
Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
¢ or 4
2
Press
VOLUME."
3
Turn the control dial to set to the desired
volume.
You can set it from "VOL 00" to "VOL 30" or
"VOL 50" (depending on the amplifier gain
control setting: see page 38).
4
Press SEL (select) to finish the setting.

Automatic clock adjustment

When shipped from the factory, the clock built in
this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS
signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also "Changing the general settings
(PSM)" on pages 34 and 35.
1
Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
¢ or 4
2
Press
ADJUST."
3
Turn the control dial counterclockwise to select
"ADJUST OFF."
Now automatic clock adjustment is canceled.
4
Press SEL (select) to finish the setting.
To reactivate clock adjustment, repeat the
same procedure and select "ADJUST ON" in
step 3 by turning the control dial clockwise.
Note:
You must stay tuned to the same station for more than
2 minutes after setting "AUTO ADJUST" to
"ADJUST ON." Otherwise, the clock time will not be
adjusted. (This is because the unit takes up to
2 minutes to capture the CT data in the RDS signal.)
to select "TA
to select "AUTO
19