Troubleshooting - Toolson KGZ3400 Originalanleitung

Troubleshooting

Problem Possible Cause
The motor does not run. Faulty motor, power supply cable or plug.
Burned out fuses.
The motor starts slowly Low power supply voltage. Damaged
and does not reach windings. Burned out capacitor.
running speed.
Excessive motor noise. Damaged windings. Faulty motor.
The motor does not Overloaded circuit due to lighting, utilities
reach full power. or other motors.
Motor overheats easily Overload of the motor; inadequate
cooling of the motor
Decrease in cutting The saw blade is too small (sharpened
power when sawing too often)
The saw cut is rough or The saw blade is dull; the tooth shape is
wavy not suited to the thickness of the material
The work piece rips or The cutting pressure is excessive or the
splinters saw blade is not suited to the application
Help
Have the machine checked by skilled personnel. Do not
try to repair the machine yourselves as it may be danger-
ous. Check the fuses and replace them if necessary.
Ask for the Electricity Board to check the voltage availa-
ble. Have the machine motor checked by skilled person-
nel. Have the capacitor replaced by skilled personnel.
Have the motor checked by skilled personnel.
Do not use other utilities or motors on the circuit to which
the cutting-off machine is connected.
Prevent overloading the motor when cutting; remove
dust from the motor to ensure an optimum cooling of the
motor
Re-adjust the end stop of the saw unit
Re-sharpen the saw blade or use an appropriate saw
blade
Use the correct saw blade
19 І 180