Kenwood KMM-303BT Bedienungsanleitung Seite 11

BLUETOOTH®
BLUETOOTH — Mobile phone
Receive a call
When there is an incoming call:
– All the buttons (and display for
– The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. ( [AUTO ANSWER])
During a call:
– For : The buttons and display illuminate according to the
settings made for [DISPLAY]. ( 15)
– If you turn off the unit or detach the faceplate, the Bluetooth connection
is disconnected.
To
Answer a call
Reject a call
End a call
Adjust the phone volume
[00] to [35] (Default: [15]*)
Switch between hands-free
and private talk modes
* Not applicable for iPhone. During a call, the unit synchronizes the phone volume on the iPhone
to the unit.
) flash.
On the faceplate
Press or the volume knob or one of
the number buttons (1 to 6).
Press .
Press or .
Turn the volume knob during a call.
• This adjustment will not affect the
volume of the other sources.
Press during a call.
• Operations may vary according to the
connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to make a selection (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN –10 — +10 (–4): The sensitivity of the microphone increases as the
number increased.
NR LEVEL –5 — +5 (0): Adjust the noise reduction level until the least noise is
being heard during a phone conversation.
ECHO CANCEL –5 — +5 (0): Adjust the echo cancellation delay time until the least
echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to make a selection (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 1 — 30: The unit answers incoming call automatically in the selected
time (in seconds). ; OFF: Cancels.
BATT/SIGNAL (For
AUTO: Shows the strength of the battery and signal when the unit
detects a Bluetooth device and the Bluetooth device is connected. ;
OFF: Cancels. Clock time is shown.
.
Default: XX
.
Default: XX
)
ENGLISH
9