Create Pdf Report; Delete Data - VOLTCRAFT DL-260A Bedienungsanleitung

14. Create PDF Report

• Connect the data logger to your computer.
• A PDF report is produced automatically. Red LED control light (2) is on and "USB PDF" is shown in the LC display.
Do not disconnect the data logger from your computer during this period.
• Open the data logger drive on your computer.
• Once the PDF file has been generated successfully, "PDF" disappears from the LC display (4). "USB" remains on
the LC display.
• Select and open the PDF file.
• The PDF report contains general device information, data logger settings, alarm statuses and a graph showing the
measured values during the recorded time.
• Save the PDF file on your computer and close the file.
• Disconnect the data logger from your computer.
Depending on the number of stored measurements, generating the PDF file may take up to approximately
30 seconds.
Only the maximum and minimum measurements during recording will be shown in the PDF report but not
during the pause function.

15. Delete data

Generate and save the PDF report before deleting measured data, if needed.
Deleting data does not affect the configuration settings.
• Press and hold buttons DOWN (5) and ENTER (7) and connect the data logger to your computer. "USB" is shown
in the LC display. All data is deleted.
• Release the buttons.
• The data logger driver on your computer is empty, that means all data was successfully deleted. Disconnect data
logger from your computer.
51