VOLTCRAFT DL-260A Bedienungsanleitung Seite 41

"MEASUREMENT" options - "BASIC SETTING"
Select "MEASUREMENT" in the navigation bar and enter settings in "BASIC SETTING".
LOGGER ID
RECORD START
CONDITION
RECORD START
CONDITION
STOP STYLE
START TIME
STOP TIME
START DELAY
MINUTES
SAMPLING RATE
RECORDING TIME
Logger ID is a four digit identifier. Enter a number between 0000 and 9999 e.g. 0014.
Use different logger IDs to identify data loggers with e.g. different configuration file for
different usage.
Select one of the following options to determine when data logger starts recording. Each
option has a default stop setting.
"IMMEDIATELY UNTIL MEMORY FULL": Data logger starts recording data immediately
until the memory is full.
"START UPON KEYPRESS": Data logger starts recording after holding button ENTER (7)
pressed for few seconds. Data logger stops recording until memory is full.
"START UPON START TIME": Data logger starts recording at a defined date and time
until the memory is full.
"START/STOP TIME": Data logger starts and stops recording data at a defined date and
time.
"CIRCULAR LOGGING": Data logger starts recording immediately and circularly. The
newest data overwrites the oldest data. It stops recording/logging once the battery is
depleted or "CIRCULAR LOGGING" has been replaced by another "RECORD START
CONDITION" during configuration.
Select one of the following options to determine when data logger ends recording.
"NONE": No stop condition is specified. Data logger stops recording based on the
"RECORD START CONDITION" setting.
"STOP BUTTON": Data logger stops recording after holding button ENTER (7) pressed
for few seconds.
"AFTER PDF CREATED": Data logger stops recording after PDF report is generated.
Define date and time when to start recording data.
Define date and time when to stop recording data.
Define delay time of immediate start of recording.
Define how frequent the data logger measures and records data in "MINUTES" or
"HOURS".
When using the data logger at extremely low temperatures, choose a longer
sampling rate to decrease power consumption and to prolong the battery life.
This value is automatically calculated based on the sampling rate and cannot be set by
the user.
41