Kenwood FDP60 Bedienungsanleitungen Seite 8

before plugging in
l
Make sure your electricity supply is the same as the one
shown on the underside of your appliance.
l
This appliance conforms to EC Regulation 1935/2004 on
materials and articles intended to come into contact with
food.
before using for the first time
1 Remove the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should
be discarded as they are to protect the blade during
manufacture and transit only.
2 Wash the parts see 'care & cleaning'
key
processor
power unit
2
bowl with drive shaft
3
detachable drive shaft
4
lid
5
feed tube
6
pushers
7
safety interlocks
8
speed/pulse control
9
power on light
bk
cord storage (at back)
blender
bl
filler cap
bm
lid
bn
goblet
bo
sealing ring
bp
blade unit
bq
base
A - standard attachments
br
knife blade
bs
dough tool
bt
max capacity disc
ck
2mm slicing/grating disc
B - optional attachments
Not all the attachments listed below will be included with your
food processor model. Attachments are dependent upon the
model variant. For more information or to order additional
attachments refer to the "service and customer care" section.
cl
dual whisk (if supplied)
cm
4mm slicing/grating disc (if supplied)
cn
extra fine grater disc (if supplied)
co
French fry disc (if supplied)
cp
folding tool (if supplied)
cq
mini bowl and blade (if supplied)
cr
grinding mill (if supplied)
cs
citrus juicer (if supplied)
ct
juicer extractor (if supplied)
to use your food processor
1 Fit the bowl to the power unit. Place the handle towards the
right hand side and turn forward
2 Fit an attachment over the bowl drive shaft.
Note: Detachable drive shaft
when using the discs, mini bowl, whisk, folding
tool and citrus juicer.
l
Always fit the bowl and attachment onto the processor
before adding ingredients.
3 Fit the lid ensuring the top of the drive shaft/tool locates into
3
the centre of the lid
l
The processor will not operate if the bowl or lid
are not fitted correctly into the interlock. Check
that the feed tube and bowl handle are situated
to the right hand side.
4 Plug in. The Power On light will come on. Select one of the
following options: -
Speed Control – manually select the required speed (refer to
the recommended speed chart).
Pulse – use the pulse (P) for short bursts. The pulse will
operate for as long as the control is held in position.
5 At the end of processing turn the speed control to the 'OFF'
position (Align the speed control with the power on light
l
Always switch off and unplug before removing the
lid.
important
l
Your processor is not suitable for crushing or grinding coffee
beans, or converting granulated sugar to caster sugar.
6
1
until it locks.
2
should be fitted
.
9
).